share this post
on this page
A fixed energy contract gives you certainty about your electricity price. So does an energy management system (EMS) still make sense? For most businesses with a large grid connection, yes. Your contract fixes the price per kilowatt-hour and nothing else. Your grid costs, your peak demand, what happens to your own solar power and the headroom on your connection can all still be controlled.
This article uses the Dutch tariff structure, with figures from Liander and the ACM. The principle applies wherever grid operators charge for peak demand.
“We’re locked in until 2028, so control won’t save us anything.” That’s true for one line on your energy bill. It isn’t true for the rest.
- On a large connection in the Netherlands (above 3×80 amps), you pay the grid operator for your contracted capacity and for your highest peak each month. A single quarter-hour with everything running at once counts for the whole month.
- At Liander, that monthly peak costs €3.57 per kW per month on medium voltage in 2026. A peak that comes in 150 kW lower, month after month, saves around €6,400 a year.
- Solar power you use yourself doesn’t have to be bought in and carries no energy tax. What you feed back usually earns little under a fixed contract.
- Growing within your existing connection is a question of control, whichever supply contract you’re on.
- On 8 October 2026, the ACM published a draft decision on time-dependent transport tariffs for large consumers. When you draw power is going to matter, even at a fixed supply price.
Your contract decides what a kilowatt-hour costs. It doesn’t decide how many you draw at once.
What does a fixed energy contract fix, and what doesn’t it?
A fixed energy contract fixes the supply price per kWh, usually for one to five years and sometimes with separate peak and off-peak rates. Your energy bill has three parts: supply, grid costs and taxes. The contract with your supplier only covers the first.
What sits outside that contract:
Fixed, variable or dynamic: what can an EMS control?
The type of contract determines which cost items an EMS can influence. Grid costs, self-consumption and grid headroom can be controlled under any contract. Only steering on the electricity price itself depends on what you’ve signed.
| Cost item | Fixed contract | Variable contract | Dynamic contract |
|---|---|---|---|
| Electricity price · differs per contract | |||
| Price per kWh | Fixed (possibly peak/off-peak) | Changes monthly or quarterly | Changes hourly or per quarter-hour |
| Steering on electricity price | Limited, peak/off-peak only | Limited | Yes, on hourly or quarter-hour prices |
| Grid costs and headroom · controllable on any contract | |||
| Peak demand (kW max) | Controllable | Controllable | Controllable |
| Contracted capacity | Controllable | Controllable | Controllable |
| Solar self-consumption | Controllable | Controllable | Controllable |
| Growing within your connection | Controllable | Controllable | Controllable |
On a fixed contract, you lose one source of savings. The other four remain available.
How much does peak demand cost on a fixed contract?
Your peak demand costs money every month, regardless of your supply contract. The grid operator charges your highest quarter-hour peak of the month at a fixed rate per kW. According to Liander’s 2026 tariff sheet, that’s €3.57 per kW per month on medium voltage (136 to 2,000 kW), on top of €2.29 per kW per month for your contracted capacity.
A worked example. A business has a contracted capacity of 800 kW. On an ordinary Tuesday at half past seven, production starts, the HVAC kicks in and ten vans are plugged into the chargers. For one quarter-hour, demand hits 780 kW. For the rest of the month, it stays below 600 kW.
That single peak sets the kW max charge for the whole month. If the peak came in at 630 kW every month, that’s 150 kW less. At €3.57 per kW per month, that’s €535 a month, or just over €6,400 a year. The example is indicative: tariffs vary by grid operator and voltage level, and how much peak you can avoid depends on your site.
An EMS prevents peaks like this by shifting charging sessions, deploying a battery at the right moment and briefly turning down non-critical loads. Our article on peak shaving explains how it works.
Does it pay to use your own solar power?
Yes. On a fixed contract, solar power you use yourself is worth more than solar power you export. For every kWh you consume on site, you pay no supply price and no energy tax. For every kWh you export, you only get the feed-in rate from your contract, which is often well below what you pay for consumption.
Businesses on a large connection were also never covered by the Dutch net metering scheme (salderingsregeling). Exported power was never offset against consumption at full price for them.
An EMS shifts consumption to the hours when the sun is shining. Think of charging the fleet around midday, a battery storing the surplus for the evening, or cold stores being brought down to temperature a little earlier. Our article on smarter feed-in covers the principle in more detail.
One caveat: if your fixed contract has peak and off-peak rates, the gap between them is usually small. Charging and discharging a battery on that gap alone earns very little. A good EMS calculates this for each situation and won’t cycle the battery for a few cents of profit if the wear costs more.

Generated with AI
Can you grow within your existing connection?
Often, yes, and your supply contract plays no part in it. Whether you can expand depends on the headroom within your contracted capacity. In large parts of the Netherlands, applying for a bigger connection means years of waiting. Electrifying, building a charging hub or adding a production line then has to happen on the existing cable.
This is where control often pays off most. By spreading demand, absorbing peaks with a battery and matching consumption to on-site generation, more fits on the same connection. The fire station in Zeist is an example. Unica made the station more sustainable with solar panels and a battery within its existing grid capacity, in a region where new connections were on hold. Tibo EMS controls the installation.
For other routes, read our overview of what your business can do about grid congestion, or see RVO’s overview of options (in Dutch).
What do time-dependent grid tariffs mean for a fixed contract?
Time-dependent grid tariffs make the timing of your consumption cheaper or more expensive, even if your supply price is fixed. With Dutch regional grid operators, the transport tariff has traditionally not depended on when you draw power. Large consumers on TenneT’s high-voltage grid have had time-dependent tariffs since 2025.
On 8 October 2026, the ACM published a draft decision by the ACM to introduce the same for businesses with a large connection to the regional grids. Drawing power at quiet times becomes cheaper, at busy times more expensive. When the draft was published, no start date had been set. The direction is clear, though: businesses that can already shift their consumption won’t need to change anything once the new tariffs apply.
What should you do when your fixed contract ends?
When your fixed contract ends, you choose again: fixed, variable, dynamic or a mix. That choice is better made with data on your own consumption than on gut feeling. An EMS that has been running for a while shows how much flexible capacity you have and answers questions that are otherwise hard to answer:
With those figures, you’ll know whether dynamic energy tariffs make sense for you, or whether a new fixed contract is the better fit. And if you switch, the control is ready on the day the new contract starts.

Generated with AI
How does Tibo EMS work on a fixed energy contract?
In Tibo EMS, you enter your contract details, including peak and off-peak rates if you have them. Every five minutes, the system calculates a new control schedule for the next 48 hours, based on real-time metering data, the weather forecast for your solar panels, your contracted capacity and the status of your battery, chargers and other assets. On a fixed contract, the emphasis is on preventing peaks, using your own solar power on site and staying within your connection. If you later move to a dynamic contract, you update the contract details and the system starts steering on hourly prices as well.
What would control deliver at your site?
Whether smart control pays off on your fixed contract depends on your load profile, your assets and your connection. A site with solar panels, chargers and a tight connection has different opportunities from an office without on-site generation. In a demo, we show how Tibo EMS works and look at the cost items that are open in your situation. Book a demo and bring your latest grid bill.
Frequently asked questions
follow us
Don't miss the next spark.
Subscribe and catch the latest in energy management.




